Cowl hood

[gharris79]

Is there a company out there that makes cowl hoods for a 87 Cutlass? I want at least 2".

 

[FE3X CLONE]

VFN Fiberglass
Glasstek
Unlimited Products

Or you can have steel scoop molded onto your stock hood.

 

[gharris79]

Is that what's on the car in your signature? I want to stay away from molding a scoop on. I'm going to look into the one you mentioned. Thanks

 

[gharris79]

Found this on Facebook. Does anyone know what type of hood is on it?

 

[FE3X CLONE]

The one in my sig is a just a steel scoop that was molded to the stock hood.

Like you, I wanted to stay away from the little ridge/molding that runs up the center on almost ALL aftermarket fiberglass cowl hoods.

 

[Qdub24]

VFN Fiberglass
Glasstek
Unlimited Products

Or you can have steel scoop molded onto your stock hood.

Harwood

 

[gharris79]

Everyone I look at is 3 1/2" and up. I only want a 2" rise.

 

[FE3X CLONE]

Are you going with the cowl hood because of clearance issues or is it purely for looks? If you don't need it for clearance you could go with a H/O hood bulge.

 

[gharris79]

At first it was for clearance but I changed my air cleaner. All for looks now.

 

[BuWaGone]

Unlimited Products is junk, very poor fit and finish
Harwood only make pin on
Glasstek is the only fiberglass bolt-on, I really liked my 4" and they make a 2"

Your only other choice is to buy a metal cowl and weld it on.