Drag Racers Step In

Status
Not open for further replies.
Car: 1979 Malibu 2-door
Engine/Mods: Alum. Headed 10.1 406/ 2400 holeshot/ Built 700r4/Stock monte ss 7.5" 3.73 posi-trac
WHP:??
1/8: 8.80's (2.20-2.30 60 foot times)
MPH: Can't remeber

Bike: 05 ZX-6R (636)
Engine/Mods.: Stock
WHP: 130
1/8: 7.02
MPH: 101.3
 
On Motor:

Car: 78' Olds Cutlass "Bad78Cutlass"
Engine/Mods: 327 .30 over Sbc ( Race parts inside of it, but won't tell)
Whp: About mid 500hp+
1/4: Just finished it. Maybe maybe a 12.20 or so.
Mph: ?

On Nitrous:

Engine/Mods: 327 .30 Sbc with 250 shot
Whp: Almost if not 800hp
1/4: Maybe 10's
Mph: ?
 
car: 98 Z28
engine: LS1, lid, catback, dead stock everything else
whp: about 290
1/4: [email protected]
1/8: [email protected]

not a g-body cuz im not done yet.

at lebenon valley, NHRA div1
DonsZ-2-1.jpg
 
No drag racer engine builder here but here goes.

87 Olds 442, stock 70 rebuilt Cadillac 500 9.9-1, home street port w bigger valves, mild cam & springs. 12.60 @ 110mph as driven pump gas full exhaust radial tires.

87 Buick GN, engine untouched, mods in signature 12.50 @ 109 as driven pump gas radial tires full exhaust.

I like to say that they are hybrids they burn both gas & rubber.
 
drag racing

car 86 monte carlo ss

engine 383
whp ?
1/4 11.50
60ft 1.70
1/8 7.35
1/8 mph 94
1/4 mph 118
this is on the motor with drag radials
i hope to spray it after i get the motor broke in :twisted:
 
1985 Cutlass in sig, with my old cam, less gear, smaller carb, and no posi:

On a day an electrical short would not let it rev above 3500-4k, it ran:

1/8 mi.: 9.4

60 ft: over 2.25 sec.

MPH: unknown.

Stock 1998 Nissan Frontier, 4 cyl, 5 speed

1/8 mi: 11.20

60 ft: forget

MPH: forget that too

Stock 1995 Nissan Sentra (beater, now deceased) 1.6 4cyl, automatic

1/8 mi: 12.50

60ft: does it even matter?

MPH: Ditto
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor