drive shaft

[ohioelcamino]

well guys the bb is almost ready to fire up and i went to put the driveshaft in and yes i forgot it is too long. if i had a driveshaft shop near i could get it cut but i dont . does anyone know of a driveshaft from another car that will fit and yes im using the th400

thanks

fil

 

[-83MONTESS-]

With my TH400 I had to use a driveshaft from a late 70s Monza. Im not sure of the difference between our wheel bases though.

 

[JBreu]

I have a driveshaft that was cut for the th-400 that has the 400 yoke and it has been balanced as well. It's sitting around in my garage collecting dust. I don't need it anymore as I went with the 700r4 transmission. BTW, Your location in your sig would help your cause..Only saying 8)

 

[ohioelcamino]

ooops on the location i thought i did , i didnt notice it wasnt there.

 

[RegalBegal]

Measure your drive shaft and figure how much shorter you need it. Then head down to the bone yard with tape measure in hand. I'll bet you'll find one. Plus, you can pick up the correct yoke while your there if you don't already have it.

 

[ohioelcamino]

well i found a place in cleveland only 50 miles away, they said 65.00 cut and balanced i dont think thats a bad deal. thanks everybody for the responses. this site is great.