engine 305

Status
Not open for further replies.

SSmooth84

Greasemonkey
Mar 12, 2019
112
43
28
Sandiego,California's
Can anyone tell me were the three bottom parts with the hose connectors sticking out connect to ?
 

Attachments

  • 20190319_114453.jpg
    20190319_114453.jpg
    5.5 MB · Views: 239
  • 20190319_112146.jpg
    20190319_112146.jpg
    932.7 KB · Views: 222

airboatgreg

Comic Book Super Hero
Oct 2, 2016
2,863
3,112
113
Front one is cannister purge vave, middle is cannister purge valve temp control switch, 3rd is probably for the heat riser
 

airboatgreg

Comic Book Super Hero
Oct 2, 2016
2,863
3,112
113
No I don't. You have some missing stuff. The purge valve is probably bad as they had an issue in the day and one of the fixes was not to fasten it to the bracket. If you are not in a smog state I would not worry about and neaten it up. Carb has to vent and looks like ok depending on where the top hose goes. Probably cannot get replacement parts to bring back to original
 

Clone TIE Pilot

Comic Book Super Hero
Aug 14, 2011
3,831
2,568
113
Galaxy far far away
Knowing the year would help, as the emission routing changes from year to year.

They still make and sell those parts. It is best to keep the Evap system as it is closed venting for the gas tank, keeping moisture out of the gas tank which helps to prevent rust and gum build up. Removing the Evap will require open venting for the gas tank which will allow moisture into it, causing the fuel to go bad faster as well as promote rust and gum build up in the tank and fuel system.
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor