Looking for drivers 60/40 power seat tracks

[83partshauler]

Anyone out there have either a set or just the drivers side power seat track for a 60/40 split they're looking to sell?

 

[SafariWagon]

Same as a bucket seat power seat bracket. I know I have both. I usually see them in the $100-150 range on Ebay. I have an extra one, but I think I want to hang on to it for now. they are out there.

 

[83partshauler]

Well either or I guess. The plastic that houses the motor on mine is broken and is stuck in an uncomfortable driving position.

 

[Mat1227]

My 87 442 has a power seat (drivers side) and I have a 87 Supreme Brougham 60/40 power seat (drivers side) the bolt pattern on the seats is not the same, they do bolt to the floor bolt pattern, but not the seat bolt pattern. Maybe other years would work, I don't know that, but 87 doesn't work. I kept it because I was going to make the passenger seat power. I would sell you the one I have for the 60/40 seat (drivers side) $100 plus shipping. If your interested, I'll get it out and take some pictures for you. I'm in NE Ohio (south of Cleveland). If your local you are welcome to pick it up.

Mark

 

[83partshauler]

Hi Mark - thanks for the info. I'd be interested in purchasing your seat track. If anything I can cut the mounting tabs off and reweld mine on to make them bolt up. I'd be interested in pix to see the condition and if they're the same for the most part.

Thanks - Steven

 

[clean8485]

The 60/40 power bench seat track is different from a bucket seat power track. While they both bolt to the floor in the same spots, the seat mounting points on the 60/40 track are approximately 1" wider apart than on a bucket seat power track. I know this from personal experience with 2 different GM 60/40 power seat tracks. On one of them, I had to fabricate adapter brackets that would allow me to mount a GM bucket seat to it.

 

[83partshauler]

What about just swapping the motors over? Basically my seat tracks are fine - it's the plastic housing that encases the motor/gears basically disintegrated.

 

[Mat1227]

Pictures attached.

 

[83partshauler]

Cool thanks Mark. Lemme compare it to mine - looks pretty much the same. Whats the width spacing on the rear outter bolt holes center - center as well as the top mounting holes?

 

[BPTTONE420012]

check the for sale / trade forum on here... someone has a set of 60/40 manual and a set of power for 100-140 bucks... also has seats too...