Just drove it over 30 miles. Attempted to remove the cap and there was pressure. Both top and bottom rad. hoses were warm and both heater hoses as well.
NO HEAT!
- Thread starter crazy'boutOlds
- Start date
- Status
I think it's the slider switch in your car it's not opening up the flap door behind the glove box. I usually have to close that because I get too much heat in the summer time with the headers and T Tops off. I would check it out there
you will see an L shape black plastic bracket with a white plastic clip. that's where the long thin threaded bolt attaches to. if that is not attached it will only circulate cool air.
you will see an L shape black plastic bracket with a white plastic clip. that's where the long thin threaded bolt attaches to. if that is not attached it will only circulate cool air.
crazy'boutOlds said:
Here are pics of the bracket. I found the pics from an EBay listing here ► http://www.ebay.com/itm/GM-OEM-HEATER-C ... 5aea1085ab
Even though it's for an ElCO it's still the same set up
Hope it helps
Even though it's for an ElCO it's still the same set up
Hope it helps
Attachments
Well, brought it inside at work today. It's the blend door cable. Once it's put in the defrost position, it doesn't return to the heater position.
You don't happen to have a vacuum operated valve on the heat line from the engine to the heater do you? Could be stuck...
- Status
