I built a chevy 350 with a 350 trans. My crossmember sits back about 6 maybe 6 and a half inches away from my mount. I made a plate so it will bolt up. But now my steel plate is bending. What should I do?
please help ! 350 turbo crossmember will not reach
- Thread starter bobby whitmire
- Start date
- Status
What transmission was in it before? Did it have an over drive trans. If it did it could be why the crossmember was sitting further back. You may need a th350 specific crossmember if you don't have one. Plus the th350 crossmember uses different mounting locations on the frame.
As was mentioned above sounds like the crossmember is located in the overdrive trans location. You'll probably need to move it forward or acquire the proper one .
Yeah I've seen that. I have looked at all the threads on here. Lol I have extra holes on the driver side. But not on the passenger side. I just hate to drill a hole into my fuel line running through my frame. It seems like they would make something to fix this problem.
Is it the 200 3 speed or the 200-4R 4 speed over drive? If it's the od trans you will need a cross member for the 200/350 which is a different mounting location.
If this is the case you will not need to drill holes just move them to the location for the cross member you are using.
If this is the case you will not need to drill holes just move them to the location for the cross member you are using.
Last edited:
- Status
Similar threads
