Transmission crossmember

[Street Sweeper22]

Everything that I have read about the th200 and th350 says that they use the same crossmember but when I asked JEGS they said this crossmember would not work in my car since it has a th200. Anybody have any real world info? Thanks

 

[Ribbedroof]

They're probably thinking 200-4R

TH200 and TH 250/350 use the same crossmember

 

[454GrandPrix]

Here is everything you need to know:

 

[Street Sweeper22]

Have you guys ever used these crossmembers and are they any good?

 

[timo22]

I bought one used for my Bonneville SBC conversion. Before I yanked the drivetrain, I slid it in for a test fit. It lined up fine and had about 3/8" clearance from the floor. I'll be using it on my project....timo22

 

[Qdub24]

I'm not a fan of the Jegster crossmember. It wouldn't fit my headers' collectors.

 

[melloelky]

https://gbodyforum.com/threads/dual-hump-crossmembers.66519/

 

[Street Sweeper22]

Thanks for the feedback. My car has the original 3.8 and th200 which are working fine other than being turds. The exhaust is trashed though. I scored some headers and wanted to run a dual exhaust set up so that when it is time to do an engine and transmission swap I at least have the exhaust done. I’m probably gonna roll with the cheap since I’ll probably have to buy another one later.

 

[timo22]

I'm not a fan of the Jegster crossmember. It wouldn't fit my headers' collectors.

I forgot about that part. Fortunately, I am running Hedman shorties on my Bonneville. If you are planning on running long tubes , that's definitely something to consider. timo22

 

[Jim hopper]

I had the local welding shop Take my stock one cut it and cut a pipe in half and weld it in wher the jegs one has the boxed spots and it works fine for me