Who is running 3" True Duals if so what crossmembers are you guys using? Thanks in advance. I'm thinking about running 3" duals with thrush welded mufflers and turn downs before the axle.
True Dual 3" Pipes
- Thread starter All Motor Boys
- Start date
- Status
I'm running 3" from the headers back w/Flowmaster 40s, an x-pipe, and turndowns at the rearend on my '83 Cutlass. I ordered a Summit brand crossmember for a G-body w/ TH350 trans, but received a crossmember labeled G-Force. Four TH350s later, my crossmember looks just good as the day it was installed.
where is your x-pipe located at? and did you get it premade. Im going to have to get another crossmember. My 406 need to breathe flatting a pipe is not an option.
The shop that did my exhaust also fabbed the x-pipe for me. My x-pipe is located approximately at the center of my driveshaft.
most shops out here wont touch a car without cats. I will do some checking around tmrw. Thanks for the input.
No problem. I ran into that same issue when I came out here to Texas. One of many reasons I took my Cutlass back to GA.
- Status
Similar threads
