Wiring 4 speakers on 2 channels

Status
Not open for further replies.

78 Green Lemans

Apprentice
Aug 15, 2009
94
2
0
Penticton BC Canada
I want to wire 4 speakers off my front two channels of my amp, the amp is 2ohm stable (stereo) and i have done it with the same model amp before. The new part of this install is the inline hi-pass filter to the dash speakers.
Im basically wanting to wire it so the filter doesnt affect the other two on these channels.
I hope this makes sense. :?
 
if all spks are 4 OHMS just wire + of each right, to + on the amp right, - of each right to - of right chan of amp. This will also allow the crossover to work on 1 set of spks.

2 4Ohm spks wired in parallel (all + to +) = 2 Ohms at amp
2 4Ohm spks wired in series (+ from amp to + on 1 spk, the - from spk 1 to the + on spk 2, - from spk 2 to - on amp) = 8 Ohms at amp

Parallel crossover only affects the spk its on
series a crossover will affect all spk in the series.
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor