It doesn't look too bad, however I'm not familiar with the way elkys are put together. seems like the damage was contained just to the lower section. How does the door jamb look? any signs of cracked paint ?
I've toyed with the idea of LED tails in the cutty. haven't found a good layout for them being they are tall and skinny and not like the buick. making the boards and stuff for the taillights isnt hard, just mounting them in the lens and potting them well to prevent corrosion and shorts. Throw...
I figured it out, nothing looked lined up until i started tightening stuff down. Turns out the picture i have originally posed was the correct orientation of the spacer and the bracket.
hey guys, in the middle of replacing my water pump i didnt take note of the way the a.i.r pump bracket attaches with the a/c pump. I have the front bracket in front of the ac pump bracket. on the back side i have the spacer as seen in the picture followed by the air pump bracket. however i...
crapsman stuff has gone down hill in the last decade or two. I just got a good deal on a jack, creeper, jack stand combo. Wouldn't you know it the jack was unable to maintain pressure and slowly drop the car back onto the floor. Here is the best part, I got it replaced, but the manager of...
Thanks Anubis , its been a little while since i've been on the forum, hopefully with the weather warming up and getting things situated, i hope to get this part of the project going again.
I remember growing up these cars were everywhere, then when i started to look for one as my first car back in 99 / 2000 they started thinning out. As others have said the Northeast weather / road salt turned most of them into rust then add the cash for clunkers and now im lucky to see one...
the PTFE you are talking about will hold up well under the chemical environment they are subjected to, in addition the heat cycling shouldn't bother it too much. I use PTFE sheets in my environmental chambers at my job. They last no problem at 170C = 338F
I found my 8.5 ( 3.73 open rear) locally here in NJ a few years back, Came from an 84 H/O IIRC that was t- boned and the Kid bought it thinking it was repairable. He did not know what he had being he cut the shifter cable for the lightning rods. I got my rear end with the e brake cables and...
the Idea I have is to use one or two sensors up on the radiator like most typical stock setups I've seen are. the additional sensor would be on the engine, to monitor the temperature on the block side. my idea behind this is to keep the temperature as stable as possible and using the additional...
The relay control is a good basic way to start out, and yes amperage of the fans has to be considered to a point. You guys gave me a great idea for a programmable fan control project, really simple to do with the arduino micro-controller development kit i have. A high/low fan speed can be...
check out http://www.justclippsauto.com/
ken and his wife are great people to deal and helped me find my lower chrome molding clips for my cutlass and the landu top clips
i dont know if they remember me, but tell them dave with the 86 cutlass from NJ said hello!
yah i not sure if that's the same brochure I have, but the two pages you posted look similar except i think mine illustrated the dark blue dash with the rallye pac cluster and different wheel. I haven't dug it outt of my book shelf but i do recall they have a check list grid with the possible...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.