Search results

Re: New Aftermarket Cutlass Supreme License plate holders so In stock yet? Thanks John

I had the same issue but my shake started at 55. I had 2 bad motor mounts and a bad trans mount, once replaced no more shake. This was on an 87 Cullass with a 3.8.

Re: Thanks from me too

oh yea, check to make sure the flap in the air cleaner housing tube is open.

Hopefully some who know for sure will comment because I am in the same boat with not passing emissions but these are 2 things that were suggested to me to do. I turned in the 2 mixure screws at the base of the carb 1/2 turn. I believed this helped as the idle increased a bit which if I...

Thanks for the replies. I already have new upper A arms, so now I think I am goiing to go with PST lower A arms and their Steering Linkage Kit with new front springs. Hopeing to have it done in one day in the back corner of the lot. :) I will take to STS tire get new tires and a standard...

Thanks guys, the car is not a DD but I do live in an apartment and I cannot leave it apart. To be honest I am not supposed to be working on it at all but oh well. Thanks for the link but I am referencing the front control arms. John

Hi - I have an 87 Cutlass Supreme Brougham with a 3.8. It is time to replace the front end but I do not want to deal with changing the control arm bushings and ball joints, I am looking to take out the old parts and bolt in the new. I ordered Dorman upper replacements which come complete. my...

I would buy one.

I have one on my 87. It Is plastic and it is ok, much better then dash it covers. It needed some trimming in spots and to install it you spread clear silicon around the outer edges of it and slide it over your original.. After 3 years mine has started to crack around the defrost cut outs at the...

it goes to a nipple in the front of the carb about center down low under the fuel filter/line

LOL - not really all that clean due to trying, lots of new parts recently. Thanks everyone. I feel much better now knowing it is for testing. John

Hi All 87 Cutlass 3.8 I noticed this clip laying on top of the engine before but never thought anything of it. Time for a tune up and I would like to put it back where it goes but cannot figure out where this green clip is supposed to call home.. One wire goes into a bundle towards the front...

got mine from mikes too

not lowered on purpose but this is what it looked like when the ball joint broke recently

I just bought and installed brakes and rotors on my Nissan Titan from brake motive. The price was great, fast shipping and did I say the price was great? here is the link to to front rotors and Pads http://www.ebay.com/itm/FRONT-KIT-PERFO ... fa&vxp=mtr

Good for you, wish I had the time and space. The carb on my 3.8 recently stated leaking, I purchased rebuilt.

Beautiful car!! I wish my 87 Brougham looked that good and was not in a million pieces.

I just changed the grommet and pcv valve yesterday in my 87 cutlass so I am going to say that is the pcv grommet and the pvc valve. On the 3.8 the pcv valve is behind the carb in the intake and the hose runs from that valve to the front bottom of the carb. My luck the hose was so brittle it...