Search results

I finally got the cutlass to the track ran a 15.2 @105mph spinning halfway down the track. All stock v6 suspension built sbc 406, th350 with 3500 stall, 342 gear 7.5 posi. http://www.youtube.com/watch?v=V4ugGTNr7dU

Whats up I wanted to know if anyone has used flux core for exhaust welding?

Hey guys I'm looking for different ideas on modding my crossmember to clear 3" duals. Thanks in advance.

Who is running 3" True Duals if so what crossmembers are you guys using? Thanks in advance. I'm thinking about running 3" duals with thrush welded mufflers and turn downs before the axle.

I swapped my 200 trans for check th350. I got the brackets for the chevy trans. The problem I have is with the transmission in park the floor shifter lever is showing reverse. The bracket on the trans is fully adjusted. Its almost like the cable is too long or one of the brackets is wrong...

Has anybody replaced their front brake lines from the proportional valve forward using bulk brake lines ? I don't really want to buy premade brake lines. Just looking for any tips? Thanks

I swapped my 200c for a th350. I ordered a floor shifter cable bracket of ebay for a gbody th350. I think im missing the part that goes on the transmission selector shaft. My new th350 came with some type of flat piece of metal bolted on the selector shaft ( the previous owner of the trans was...

I got a aftermarket radiator and I'm having trouble with finding the correct hoses. The stock ones don't work. These are my measurements I need: Thermostat Housing 1.5" to Upper Radiator 1.5" Water pump 1.75" to Lower Radiator 1.75" Thanks I'm trying to avoid using flex hoses

Hey guys I recently swapped out my 3.8 v6 motor and trans for a sbc 406 and th350 trans. The car has a floor shifter and the cable bracket don't fit on the th350 trans. Does anybody have pic of what the linkage should look like? thanks in advance

Hey whats up? How are you guys routing the fuel lines on your B.O.P engine with an electric fuel pump?

I was thinking intrepid fans and a modine 951 radiator

I sold all my gbodys and still had some parts let over and a engine on the stand. Found a deal I couldn't pass on a 1984 Cutlass. The fame and floors are solid but has a few spots of surface rust and a small hole near on of the ttops. first day home parts I already had 406 small block...

I have a 85 cutlass 70k milesone one owner rust free V6 drive only thing that isnt original is hub caps and head liner the body is a 9of10 have a frew ding from public parking. im wanting to sell i run the risk of getting it stolen leaving or getting more dings it outside every night.. How Much...

This is my first buick engine the front seal is leaking do i really need to remove the timing cover just to replace the crank seal? If you can help thanks ...

i have a 455 82 buick regal with a 342 eaton posi and stock suspension where should i strat to eliminate the wheel hop im having? can anybody help