Recent content by Billys88SS

Does anyone know what ac parts will fit my 88 monte. I did the serp setup off 90's pickup so I have that compressor. I need everything else though.

Thanks anyway guys..I found one in southern Md.

Has anyone a 200r4 with converter in ready to use condition in or around MD?

Thank you sir.

Do you have a good site for that..I've googled it before and got nothing..I have it wrote down at the house..not with me or I would put it on here for some extra eyes.

Thats the plan.. I guess then google the casting number?

Mine does not have them. It has the older heads.. I was told it might be a target master with the older 80's style junk heads. Is there a way of finding out other then the casting on the back of the block?..I'm also going to pull the valve covers to get the casting from the heads.

Should a 87-90 350 (casting 14101148) one piece rear seal and one piece pan gasket have center bolt heads?

I appreciate everyones input and advice since this post started. The main thing I've learned is to figure out exactly what the drivetrain consist of. As of the last post I've figured this much of it out... please correct me if I did it wrong.. 3:73 rear ,Open rear so I did 2 tire rotations and...

Out of all the numbers on the sticker...how do you know what number stands for what?

Ok guys.. I looked for leaks ...found none.. I did however discover that the secondaries on the Weber carb are not closing all the way..probably almost a quarter inch. Advance got me a complete rebuild kit for the quadrajet for 21.99. That is being done now. Sooo..I'm going to tune it up again...

90's chevy truck is what I got mine from. I just unbolted the ac lines from the back of the compressor and just using it as a pulley.

Thanks all for your input! I'm going to check it all out and I will let you know the outcome.

I'm also getting bigger tires .. hopefully that will help a little. Right now they are 215-65-15..What should I go with?

Thanks Dog... That's my plan as far as getting a more accurate reading. I'm looking for an overdrive transmission and My father in law is rebuilding a quadrajet for it. I guess I will start at the carb and work my way to the tank looking for a leak. I haven't seen anything when it's parked though.