Recent content by mysons80elcamino

New wheels are on. Dual exhaust with flowmasters are next.

Door panel #1 is done..

Here we go, so we bought his Elky 2 yrs ago , we then started the build very slowly due to him only being able to work during the summer to earn money for parts. We started by welding in the driver floor pan, and replacing some brakes, and started fixing some dents and little rust. That toke...

So is there a set of headers that I can bolt on to the new engine, without any modification, looking for a straight bolt on install.

I want to keep it old school I like a thick tire like old hot rods, no low profiles for me.. Thanks I'm gonna order them !!!

What would change if I went with 15x7 rather than 15x8. Just asking cause they are a lot cheaper. Lol

Anyone

Do we get a discount. I need a full cap black for a 1980 elky

Looking for some wheels i like these will they fit the 80 elky. Also these have a 4.5 bs should I get 3.75 bs for front or not. Thanks http://www.summitracing.com/parts/crr-3305734p

Thanks that helped alot. I'm sure ill have more questions thanks again

Will I need to change flywheel, or rear gears? Anything?

Also planning dual exhaust exit out rear. Do I need the crossmember or can this be done without it?

So we are about to do a 350 swap, currently this is what we got.... 1980 el camino. 267v8. With th350 trans,posi rear with 256 gears What if anything am I going to need to swap. Or will this engine be a drag and drop with what I got? I'm sticking with carbureted . Also my 267 with stock...

Yes we won. THANK YOU ALL FOR THE HELP, now help me build him one bad *ss ride.

Does anyone have a full dash cap they are looking to sell I'm looking for one and just thought i would ask around. Let me know