Recent content by Turbolq4
-
Medical: Get Your Body's Oil Pump Checked!!!
Ignorance is bliss, until it isn't. All joking aside, hope you're doing well. -
Fi-tech
I used them on a few different early Broncos. They use other companies sensors, which can be helpful if you know what they came from. I've also had issues with fuel pressure regulators, throttle position sensors, and outright injector failure. They usually work pretty well but I feel they aren't...- Turbolq4
- Post #2
- Forum: Fuel / Air / Boost / Emissions
-
Swap questions
The LS will need adapter plates for the motor mounts, the correct flex plate to go to an older transmission, exhaust of choice, and provisions for EFI if you choose to go that way. My car made fat turbo power and the chassis is fine on the street. The brakes, not so much.- Turbolq4
- Post #5
- Forum: Engine / Swaps / Driveability
-
-
What did you do to your non-G body project today? [2021]
I inherited a Jeep too. Mine is a slammed ratrod cj5 with a 440 in it. Honestly I'd prefer to have my loved one back.- Turbolq4
- Post #311
- Forum: Non-G Projects
-
What did you do to your non-G body project today? [2021]
Welcome to the Jeep life. You thought gbodies were expensive!!- Turbolq4
- Post #309
- Forum: Non-G Projects
-
My New(er) Truck
Not a fan of the v10 ferd. I drove a short bus with one in it for a few years and it got 5.5-7mpg all the time. They make power up high in the Rev range and you'll be forever wringing it's neck to make it do serious work. The 6.0 gm engine is better in every way. Tows better and gets better...- Turbolq4
- Post #17
- Forum: Non-G Projects
-
-
Whistlin Diesel - Hellcat destroyed
I blocked his channel. He will run out of money if people don't watch that garbage.- Turbolq4
- Post #34
- Forum: General Discussion
-
-
What did you do to your non-G body project today? [2020]
Re worked the track bar in my Grand Cherokee. Pushed the soft bushing out, hole sawed a hockey puck to roughly the right size. Chucked it up in the drill press and turned it down using a sawzall blade. Pressed the sleeve from the old bushing into the puck, then pressed the puck into the track...- Turbolq4
- Post #2,219
- Forum: Non-G Projects
-
What did you do to your non-G body project today? [2020]
picked this chassis up from a friend that wanted it out of his shop. Used to have a Malibu body on it and was apparently certified to 8.5. He has a rear axle that is all setup for it but he actually wants money for it. I'm undecided on what to do with it. Maybe make it into a hardcore off-road...- Turbolq4
- Post #2,218
- Forum: Non-G Projects
-
BUILD THREAD Project long time coming
Good call with the Term. I have a stock ecu and it's a PIA. Between having to spend the money to have the harness cut down or do it yourself, pay for HPT, learn that rediculousness, fuel wash the bottom end because of the huge injectors, and paying two different shops to tune the thing to where...- Turbolq4
- Post #318
- Forum: G-Body Build Threads
