Recent content by usetaboost

I thought no I'm gonna go with the summit brand covers for both cars

Wouldnt be a bad upgrade for me since the fill plug is rusted in the housing.

Good upgrade for 100 bucks of parts on my budget car.

Got a digital caliper and a dremel and just barely took out a bit of material. Went together just like factory. Thanks for the tips guys. Pin went in a little tight and the damn fill plug with seized shut but I got it done. Still gotta bleed brakes and put new studs in one axle. Hoping for...

What about the f body cars? They have 28 spline axles and an auburn carrier. Are the axle slots cut deeper to allow the smaller clips?

Could someone with a Monte ss rear possibly get me a c clip measurement?

I can't find a part number for them. Oreillys sells c clips but they won't fit the carrier. I'd like to eliminate them but money is super tight right now and will be for a few months. I just need to get it together for now. Eliminating the c clips will eventually happen for both cars.

ok I'll open them up a little and see what happens

Did you grind the inside or outside? sh*t just doesn't make any sense. I've tried 2 different sets of axle clips. Even the ones listed for the vehicle that the carrier came out of which is obviously a 28 spline. WTF

Using a GM auburn center section with the 5 spring and stock 28 spline GN axles. Everything went together perfectly but I cannot locate C clips to fit inside the center section. I tried some stock GN clips but the outside diameter is too large to fit inside the carrier. Been chasing my tail...

Since we have some locals around, I'm looking for a 3.42 or 3.73 posi rear. 7.5 ok

Grand Island huh? Have relatives there. In sioux city

Can't wait to see some video

I do have a core olds 455 carb if you have any interest in it.

Send me a pm when you are ready