Recent content by Zeus1978

  1. Zeus1978

    Trim and Emblem replacement questions?

    Ok i can disassemble and punch a rivet into the bottom hole and work it down , or open the hole in the trunk until i get a snug fit. Thank you for the info
  2. Zeus1978

    Trim and Emblem replacement questions?

    So i found, what i believe is a NOS cover from Ebay almost 10 years ago now. I bought the rivets suggested in this post. The screw is a good option i can tinker with. Would using the rivet, with maybe a piece of double sided tape on the bottom to hold it straight be a feasible option?
  3. Zeus1978

    Trim and Emblem replacement questions?

    So i found the broken lock cover, and disassembled it. i am not sure how they were able to get the rivet shot into the bottom mounting hole. Here is the rivet hole normally covered by the top cover. And i don't see a way to reinstall the spring on the cover once the bottom rivet is is shot...
  4. Zeus1978

    Trim and Emblem replacement questions?

    Ok next question. this clip on the under side of the truck lid. Does this just pry out? does it ultimately hold the lock assembly?
  5. Zeus1978

    What did you do to your non g-body project today [2025 edition]

    Laid down recycled asphalt millings down in front of my shop
  6. Zeus1978

    What did you do to your g-body today 2025 Edition!

    Replaced the rear pinion seal, changed the oil, and got here out for a 150 mile jog around area.
  7. Zeus1978

    Trim and Emblem replacement questions?

    Perfect thank you
  8. Zeus1978

    Trim and Emblem replacement questions?

    that's perfect thanks for the info
  9. Zeus1978

    Trim and Emblem replacement questions?

    So it pry's off? is there a stud or clip that holds it tight to the body? Also yes on the paint for the trunk, i have a touch up direct bush to take care of that little issue.
  10. Zeus1978

    Trim and Emblem replacement questions?

    I have a couple of questions about replacing the wheel trim in this picture. After removing the screws i pointed out in this picture. Which way does the trim slide and do i need any special tooling? I also need to install the truck lock emblem. Is there a special rivet i need to get to use...
  11. Zeus1978

    What did you do to your g-body today 2025 Edition!

    Uncovered, to get ready for the summer. Next on the list, Pinion seal, Oil change, Check /change all fluids, and a good detailing. She did fire right up after a year of sitting.
  12. Zeus1978

    What did you do to your shop today?

    Added a new still in the wrapper calendar to the wall.
  13. Zeus1978

    MALIBU I’m about to purchase the best battery 🪫 in the world

    As far as batteries go, i am super interested in these. They are lighter, and i hear can be completely discharged with out damaging them. But they are expensive.
  14. Zeus1978

    MALIBU I’m about to purchase the best battery 🪫 in the world

    this brand is also very good, i picked up a 4 battery charger on Amazon deal days for a really good price
  15. Zeus1978

    What did you do to your non g-body project today [2025 edition]

    put a new rain cap on my shop chimney. And i tried to sweep out the shop, but the wind was fighting me the whole way.
See more

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom