I need to get the tires for the 37 so I can start dialing in the front end alignment. I decided to go ahead and temporarily throw the front fenders back on and roll the truck back outside so I could see how I liked the sizes I currently have on it. In the end I decided I’m going to go down one size on the rear to get a little more rear fender clearance and take a little rake out of it.
Before I pull the fenders back off I decided to take care of a couple of other things before I get back to the alignment. The first job was to get a piece of flat stock and build a front bumper bracket so I could mount a downsized front pumper on it.
I also decided to get the exhaust cutouts run out thru the fenders.
The cutouts are mechanical and I still have to figure out if I’m going to run them with cables or build a mechanical linkage.
So not a bad week.