Hi,
I guess this is my introduction post.
I just bought my first "G-body". It's a 1979 Malibu rolling chassis. It has a Ford 9" rear end (limited slip, 3.73:1 gears), and is set up with a Th400 crossmember and drive shaft. I have a warmed up SBC 350 and a TH400 to install into it.
For the most part, the body is clean. The passenger side floor is rotten, so I ordered a passenger side floor pan to replace it. I'll probably be posting some questions about these particular floor pans in the tech area.
So, I hope to learn a lot, and get this car out on the track this coming summer.
I guess this is my introduction post.
I just bought my first "G-body". It's a 1979 Malibu rolling chassis. It has a Ford 9" rear end (limited slip, 3.73:1 gears), and is set up with a Th400 crossmember and drive shaft. I have a warmed up SBC 350 and a TH400 to install into it.
For the most part, the body is clean. The passenger side floor is rotten, so I ordered a passenger side floor pan to replace it. I'll probably be posting some questions about these particular floor pans in the tech area.
So, I hope to learn a lot, and get this car out on the track this coming summer.