so i have a 87 mcss i did the zq8 spindles with kore3 bracket for c5/c6 13.4 rotors and im run n ls1 camro calipers my question is what brake line do i need. I did read another forum said u can use the stock g body hose but u need to use the ls1 banjo bolt does this sound right or what do i need
Big brake question
- Thread starter NorthWestRider
- Start date
- Status
If you use a corvette or camaro brake line you will need to use an inverted to bubble flare fitting for the hard line. I bought them from summit since I may use the corvette lines. The banjo side you need the bolt for the caliper being used. Kore-3.com can make the braided lines for your application and it's priced at what you would pay anywhere.
The gbody hose may be a tight fit because the line may not be long enough because of where the banjo bolts on the ls caliper.
The gbody hose may be a tight fit because the line may not be long enough because of where the banjo bolts on the ls caliper.
I have both brake lines g body and f body was try n to see if i can get away wit not hav to buy brake lines
I'll give you the adapter part#is in my garage just have to get to a couple of boxes.
Edit: the adapter fittings are 271300 Edelman the adapt the gbody 3/8 24 to corvette /camaro 10mm x 1.0 bubble flare.
http://m.summitracing.com/parts/edd-271300
Edit: the adapter fittings are 271300 Edelman the adapt the gbody 3/8 24 to corvette /camaro 10mm x 1.0 bubble flare.
http://m.summitracing.com/parts/edd-271300
Last edited:
I know the ls1 camaros have the bubble flare. If those are the lines you are using the adapters will work.
No problem. Post up pics when you're done. I will be doing my c5 fronts in a couple of months. I have everything to install. Just trying to get the transmission build done first.
- Status
