Okay doing a engine swap, when I was power washing the frame and suspension to clean things up I got a little water inside the power steering box I think. When I removed the power steering lines when the old motor was pulled I just plugged the holes with some little rubber caps/plugs I found in one of my storage drawers for misc BS. I guess these plugs popped out and I didn't even notice while spraying.
I never even really focused too much on that area where the power steering box is so I figure not much water at all go in there but I feel its enough to be concerned with.
What would be proper procedure to drain the box completely so I can fill it back up when I top off all the other fluids? I'm hoping I don't have to removed the whole damn thing.
I never even really focused too much on that area where the power steering box is so I figure not much water at all go in there but I feel its enough to be concerned with.
What would be proper procedure to drain the box completely so I can fill it back up when I top off all the other fluids? I'm hoping I don't have to removed the whole damn thing.