EXTERIOR UNDEGLOW

[Melissasinave]

Hey all. I know there's lots who would be against putting under glow on the cutlass but I really want too. I was wondering if anyone has used under glow? what kits they have found were best for their vehicle. I've been looking on amazon and bought 2 sets and both are too short to reach around the car. anyone use under glow and have had any luck with certain systems thank you!

 

[fly_25]

I have used led light strips with the double sided tape on them and mounted them on my SVX, definitely bright enough and easy to install, I bought them at Canadian Tire. It would be easier to have 4 separate strips for front, back, and sides rather than one continuous one.

 

[Melissasinave]

I have used led light strips with the double sided tape on them and mounted them on my SVX, definitely bright enough and easy to install, I bought them at Canadian Tire. It would be easier to have 4 separate strips for front, back, and sides rather than one continuous one.

If I was to do that. How would I wire them ? Would they all just be wired together to a toggle switch?

 

[fly_25]

You could run one single wire (wire size capable of total circuit amps) to a fuse then one switch, then from the switch branch off into each light circuit. That's if you wanted a simple on and off. But take the power from a switched circuit so you don't kill your battery if you forget to turn them off, or just always remember to shut them off if you're going straight from the battery.

 

[fleming442]

The pimp shizzle would be to have them synced. Most LED strips these days are at least 5 color; just need hook them together. I'm sure they're out there.

 

[melloelky]

If I was to do that. How would I wire them ? Would they all just be wired together to a toggle switch?

wiring a relay's time well spent fyi