frame motor mounts

[waxman]

someone removed the original frame mounts to install a big block in my 86 cutlass and i cant figure out how to reinstall them on the passenger side there are holes in the lower control arm on the driver side that enabled me to get a socket in to tighten the bolts down but there are none on the passenger side any ideas on how to do this will be welcomed

 

[pontiacgp]

I used flanged serrated bolts and nuts. I put the bolts in facing up so I could run the nuts down by hand till the got tight and then used a ratchet on the nut to torque it. The serrations on the flanged bolt will hold it in place while you torque it. The easier way to access the nuts from under is with the lower control arm removed.

 

[waxman]

I used flanged serrated bolts and nuts. I put the bolts in facing up so I could run the nuts down by hand till the got tight and then used a ratchet on the nut to torque it. The serrations on the flanged bolt will hold it in place while you torque it. The easier way to access the nuts from under is with the lower control arm removed.

thanks i'll give that a try

 

[pontiacgp]

thanks i'll give that a try

I forgot one thing, I don't like putting bolts upside down so I used thread locker