Little b*st*rd 1986 cutlass supreme brougham

[Reegal]

real nice. i always liked the 4doors. look very luxory like. wats your plans??

not quite sure yet ..... i do want to in the future build a 454 with a 200r4 transmission but for now id like to hop up the 3.8 since it runs like a top and no sense pullin her right yet.

thats how i am with my regal. runs fine so i dont wanna open her up yet, so ima just wait till she gives out. your paint idea sounds pretty cool.

 

[littlebastard86]

little bit of bad news looks like where the rust is on the rear quarter on the driver side there was a hole under the trim and right by the light she was so rotted i touched it just to see if she was still solid to sand and my finger went through but anything can be fixed also found a quarter size hole in the driver floor but surounding it its solid unlike j* crap that one small hole u have to replace an entire floor board which i have done before so im up for the task.

 

[Reegal]

little bit of bad news looks like where the rust is on the rear quarter on the driver side there was a hole under the trim and right by the light she was so rotted i touched it just to see if she was still solid to sand and my finger went through but anything can be fixed also found a quarter size hole in the driver floor but surounding it its solid unlike j* crap that one small hole u have to replace an entire floor board which i have done before so im up for the task.

not so bad. i mean i would just start sanding down all the solid parts. i dont realy like using body filler unless i have to so any areas that arent visible to the outside i would use some sheet metal. and also if theres rust on removable parts(trunk hood fenders door etc...) depending on the seriousness, i would replace since u are going to repaint.

 

[littlebastard86]

little bit of bad news looks like where the rust is on the rear quarter on the driver side there was a hole under the trim and right by the light she was so rotted i touched it just to see if she was still solid to sand and my finger went through but anything can be fixed also found a quarter size hole in the driver floor but surounding it its solid unlike j* crap that one small hole u have to replace an entire floor board which i have done before so im up for the task.

not so bad. i mean i would just start sanding down all the solid parts. i dont realy like using body filler unless i have to so any areas that arent visible to the outside i would use some sheet metal. and also if theres rust on removable parts(trunk hood fenders door etc...) depending on the seriousness, i would replace since u are going to repaint.

right now i have to fiberglass on sheet metal do to not havein a welder since i had to move to an apartment but thats not gunna stop me ...... have to get the car on the road soon now so next year all that fiberglass crap is comein out and being fixed propperly

 

[Reegal]

cool. when i bought my 93 caprice the previous owner fiberglassed the wholy moly out of it... not cool. good luck though