Wheel Fitment Guide

[FE3X CLONE]

I'd have to check again but I had one of my front 17x9.5's with 245/45R17 tires on the back of my brother's '81 just to see if it fit.
It seemed to fit just fine. I have a 4.5" BS on them I believe.

 

[86g]

i HAVE 19 X 9'S WITH 1'' BILLET ADAPTERS UP FRONT AND 1" 1/4" BILLET ADAPTERS ON BACK WITH 6" BACK SPACING NO RUB FRONT OR REAR. WHEELS SIT UNDER BODY NO LIFT KIT NO MODS....LOOKS COOL WITH 1 AND 1/2 LIP

 

[clean8485]

OK folks. Thanks for all of your replies. I was hoping to find someone who is running a wheel like this who could verify whether or not it works. It looks like my best bet will be to do some measuring. If I do go this route, I'm looking to do it with very minimal or no spacers.

 

[84MonteCarla]

86g, post pics of that setup, I am curious to see how they tuck.

I've been drooling over 18x9.5 ZO6 wheels that I think might work with the right adaptors. I know that they'll fit my 12 bolt but up front is too close to call.

 

[83cutlassowner]

i really like these american racing torqlites. hoping to get the 18x8's with 4.5" back spacing. and 245/40-18's or 245/50-18's. is anyone running a similar combo?

 

[jrm81bu]

Check this thread out.
http://www.maliburacing.com/forum/viewt ... =2&t=92934

 

[83cutlassowner]

Check this thread out.
http://www.maliburacing.com/forum/viewt ... =2&t=92934

Damn strait! looks like i found myself some wheels. now i just have to get rid of my other set to fund these haha

 

[stroked83cutlass]

HEY GUYS, I NEED SOME INFO/SUGGESTIONS. I HAVE AN 83 CUTLASS SUPREME, IM PURCHASING SOME 15X4 PRO STARS FOR THE FRONT AND SOME 15X8 PRO STARS FOR THE REAR. IM GOING TO DROP THE FRONT 2 INCHES AND RUN A SKINNY TIRE AND FOR THE REAR IM GOING TO RUN A 26X10 DRAG RADIAL. I NEED SOME INFO FOR BACK SPACING AND OFFSETS SO I CAN PURCHASE THESE WHEELS AND MAKE SURE ITS RIGHT AND THEY DONT RUB AND THEY DONT STICK OUT TOO FAR. THANKS

 

[Tuggy24g]

I have chip foose nitrous that are 18x8.5 in the rear and front 17x8. They fit fine with no mods at all. JUst take your old rims off and bolt these rims up and your set to go

 

[Tek86]

>>>