hey everyone, another new guy here. My car is a `82 Monte. Its definetly a project but will soon be underway here soon. It will be a frame off project for certain. lil info on me....im 25 went to wyotech for autobody and street rod body and chassis fab. and am into anything that i can fabricate and my sawsall is my fav tool lol
The Ugly....
Trunk floor on drivers side...
Drivers and Pass. rear frame rails....
rear deck where sombody tried to install 6x9s i assume....
But on the good side, heres my list of mods that ive done so far....
v6 replaced with 350
215/60/15 front and 275/60/15 rear Indy 500 tires ( i work at a tire shop and they were cheap lol )
5% tint in the back windows 30% in the front two doors
Hooker comp headers into 2 1/2 inch pipe with dual origonal 40 series Flowmasters
Tach, oil pressure, water temp and volt meter all by Iequis
Things i have to replace current stuff...
350 roller block
4L60 overdrive trans
lots of sheet metal!
The Ugly....
Trunk floor on drivers side...
Drivers and Pass. rear frame rails....
rear deck where sombody tried to install 6x9s i assume....
But on the good side, heres my list of mods that ive done so far....
v6 replaced with 350
215/60/15 front and 275/60/15 rear Indy 500 tires ( i work at a tire shop and they were cheap lol )
5% tint in the back windows 30% in the front two doors
Hooker comp headers into 2 1/2 inch pipe with dual origonal 40 series Flowmasters
Tach, oil pressure, water temp and volt meter all by Iequis
Things i have to replace current stuff...
350 roller block
4L60 overdrive trans
lots of sheet metal!