Recent content by joeairforce

This is what I was going to use as a guide for doing the heads.. http://www.members.shaw.ca/gregtsmith/Head_Porting.htm

I would if I still had my car....

Welcome to the site. What part of TN you in?

Saw this during lunch break.

Listed it for sale.....

Finally got around to messing with the column again and after carefully looking at the exploded view of it in the shop manual put it back together.... Apparently when I took it apart 6-7 years ago to tighten up the tilt mechanism I had put the upper bearing inner race back in the wrong side...

Finally got around to messing with the column again and after carefully looking at the exploded view of it in the shop manual put it back together.... Apparently when I took it apart 6-7 years ago to tighten up the tilt mechanism I had put the upper bearing inner race back in the wrong side...

Anyone know where I can get just the bearings for the steering column? I need the one that goes under the turn signal switch....

Replaced the ignition switch and took part of the top end of the column apart to see why the steering wheel was loose.... Looks like I need that bearing right under the turn signal switch..... Anyone know where I can find it by itself?

After you press it down with the tool there is a ring that's around the steering shaft that you have to remove.... Then it just slides off after you remove the tool...

Nice 8)

Finished charging the battery up... Think I'm gonna replace the ignition switch before I hook it back up though as I think that's where my electrical problem is...

What are you needing help with?

IIRC one goes to the charcoal canister....

Looks custom made...... I could be wrong though...