So like I mentioned I have a pile of parts for the car. I got another set of front lower and rear upper and lower control arms for the car( thanks chophead), the fronts already had energy suspension bushings installed ( thanks ssn696) . I got matching lower bushings for the fronts, stock for the rear. Found made in the USA moog upper and lower ball joints ( amazon shockingly ). They are all currently getting the new bushings and lower ball joints installed. when they are finished I'm going to plate them and have them blasted. Then paint and install. Going to do the rear suspension in one shot then the front. So my game plan is to fix the frame 1st. got the passenger side done, just got the tank dropped and the templates traced out on the metal just have to find the time to cut them out and weld them in. After that I will clean up under side from the axle back and seam seal seal and coat with truck bed coating. The tank and straps look, just need to go over with a wire wheel and repaint. I have a new sending unit as well. Inside of the tanks looks great to my surprise. Then replace the hard lines and rubber hose on the rear. I found a deal on FB marketplace for $50 - new backing plates with new shoes, hardware, and wheel cylinders ready to bolt on. I got new 7/8 s10 wheel cylinders to swap in. Going to clean and paint the rear. I have new Energy Suspension body mounts, I have got new body bolts from Mikes Montes, and I have six new nuts and frame washers. I only need 1 washer that I know of, and 3 cage nuts. Thankfully they are all in the rear. I have new rubber fuel line and clamps for on top by the tank and over axle. Gonna see how the brake/fuel line look, but I'll prob just replace them. Body mounts are next. Stay tuned !