Search results

  1. 80Cutty

    Possibly Rear End Problem ??

    :) So I Adjusted my Detent cable and wow what a difference in acceleration and rwp!! It made instead of a chirp from the tires it lays rubber for 150ft :rofl: BUT :cry: I'm getting a terrible howling / grinding noise from somewhere ( I Do Believe the rear end ) and I Was wondering am i...
  2. 80Cutty

    Need Help With Fuel/ Carb

    So Im coming home from work tonight about a 9 mile drive home not to far but further than my normal job site halfway home i notice my car starts sputtering like its out of fuel or choking itself and i had 3/4 of a tank of gas so i stop at the light that was coming up and i go to take off and it...
  3. 80Cutty

    Trans issues

    I dont if im in the correct spot for this but i have a few ?s. Ive noticed my trans has been shifting hard or barely at all without letting go of the gas for these past few months. Well today after a long winter I took my trans pan off and found it full to the brim with trans fluid. I dont...
  4. 80Cutty

    Gearing Issues Maybe ?

    Hello I Have A 1980 Cutlass With A 455 Olds, OIds Th350, 81 Monte Carlo Rear End. My Car Shifts Into 3rd And Starts Revving Up At 40 45 mph The Rpms Just Gets Higher And Higher And I Finally Did Some Damage Blew Out A Brand New Freeze Plug The One On The Drivers Side To The Front Of The Motor...
  5. 80Cutty

    Wiring harness ?s

    Hello I have an 80 cutlass with a standard gauge set looking to upgrade to the rally gauge cluster what all do I need? Would a wiring harness with the right plugs from 83 hurst olds fit in an 80 cutlass ? Sorry if there's a topic already about this
  6. 80Cutty

    Putting a spoiler on a four door

    Hello again I have a nice spoiler and wondering If it's a really dumb idea to put a spoiler on my 4 door cutlass should I or should I not or would it look dumb
  7. 80Cutty

    Kill Switch

    Dont Know If This Is The Right Board But Im Wanting To Know How To Run A KillSwitch In My 1980 Cutlass 3.8 being that I go to school in youngstown
  8. 80Cutty

    transmission

    Hello Again I Own A 1980 Cutlass 4 door base 3.8 v6 And I Was Wondering Which Transmission These Come With The Metric 200 Or The Th 350 Im 70% precent sure its a metric 200 but i honestly dont know i have no numbers on it though please help me out :?:
  9. 80Cutty

    In need of help

    Hi I own a 1980 cutlass 4 door with a 231 v6 and metric 200 combo when your starting off and when your hauling some but she cuts cuts and returns but does this alot once you let go of the throttle she won't do what is wrong with her ? my carb was rebuilt by our carb guy then replaced I'm...
  10. 80Cutty

    Taking out rear shocks

    I have a 1980 cutlass 4 door and I'm tackling the rear end and figured that Id replace the shocks what's the easiest way to do this ?
  11. 80Cutty

    Need a pic of am m2me Rochester carb off a 3.8

    Hello Im trying to figure out the choke on my 231 m2me carb does anyone have a good pic of their choke setup
  12. 80Cutty

    My third car but I'm new to the gbodys

    Hello Im new to the g body world just figured I introduce myself I own a 1980 cutlass sedan with the 3.8 v6 (my 3rd car) I just wanted to know how do these do in the snow I'd love to know before I drive her for the winter

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor