Search results

I used to have a vacuum supply to my cannister with the factory 307 engine I since changed the engine to a 350 Chevrolet I lost all vacuum to my cannister where can I possibly get a supply .Having trouble when braking unless I'm on the throttle to get more vacuum

1985 Oldsmobile 442 Console shift Ignition will not go back to lock until you turn the lower collar on the steering column I was told that there are bushings missing can anybody tell me where I can get them or the part # Thank You

Replacing a power window motor in a 1985 Monte Carlo I seen they were using a hole saw to access the mounting bolts to remove the motor. So you do not have support the regulator?

I need some help getting some info on this transmission 200r4 from a monte carlo ss

I need the 200r4 option code from a 86-87 monte carlo ss I think it was O Z from the plate

I'm currently running all new A/C lines to my system I have 1 question the small line on the evaporator that goes to the orfice screen how does that line seal there is no place for a O ring 1985 cutlass 442

I'm trying to find out who makes the the console that fits over your original with cupholders

My car is coming out of 1st gear too early like around 10 mph do I need to loosen the cable or tighten 200r4

I'm trying to find a company that makes a cup holder that fits over the console 1985 Olds 442 bucket seats : Note this slides down over the original storage box

Most of the time after I put the car into gear and say that the car stalls out the car will not go far enough to crank until you move the lower shift bowl back is there an adjustment that I can make

I'm installing a non electrical carb on my 307 motor and I'm looking for a diagram for vacuum hook ups help if you can thank you

I'm trying to reinstall my a/c components I need to get the correct o ring seals for the drier and also the compressor

I just had the car redone and ready to replace all the striping bought the complete kit from phoenix graphics and they are not lining up like the factory ones any ideas would sure help or gm part # s

I'm looking for a small molding that's at the rear of right front fender part # 22521874

1985 Cutlass 307 4 barrel carb car starts up great cold on fast idle then it reaches the warm up point the idle starts to flutter then stalls out will restart but then stalls again I put a rebuilt Q/jet carb on new base gasket checked for vacuum leaks none found adjusted air/fuel mixture

These plastic stops fit at the bottom of the rear glass for the rear panel to rest on I'm hoping somebody can give me some kind of direction or a part # if possible help if you can Thank You

I removed this rear panel to paint not knowing that these clips were different to work with I need somebody that went through this to give me some hints on how to reinstall

1985 Oldsmobile 442 Rear glass lower reveal molding clips how to install