Search results

Thank you for your input, while It did cross my mind that I would lose some of the strength in the frame, having it explained the way you did has me thinking it's not such a good idea.

Thank you everyone

For those that have notched their rear frame rails to the seem, will a wheel with 5.25" backspace fit without rubbing on the frame?

No reason, I just saw the c5 guys using this combo without adapters so I figured it would work with mine.

Vendor, there just your standard c5 caliper to blazer spindle bracket.

There above the rotor buy maybe 1/16 and right at the bottom of the rotor surface.

For the wheels im running no clearance issue. But if your talking about rotor to caliper, I had to just do a little on the outside inner edge

Still waiting on my new control arms and shock mounts. I haven't done much to the frame because of that . But did decide to upgrade those tiny c6 calipers and rotors. Ended up going with the blazer spindles, cadillac ats brembo calipers and c6 z06 rotors, hopefully they will look a little better...

Looking good, that was alot of wire brushing

Thank you .

What is wrong with you? Your perfection makes me fill so inadequate when I work on my car. But seriously it's looking fantastic. I'm always impressed by your work, and it gives me the motivation to try and do better on my project.

Hey everyone, I need to replace my front wheel studs for some longer ones. I'm looking at the doorman website and found this model# 610-323 the knurl is 12.8mm instead of 12.73mm will this work or does anyone else have a better recommendation. Thank you

Looking good.

Finally had a little time, and put the notch in, to clear the a/c compressor

I'm getting ready to paint my frame, and was wondering how many qts. Of the eastwood chassis blk you used? Thanks

Motor ,transmission, and exhaust mocked up. Everything seems to fit . Now to pull it out and notch the frame for the A/C compressor.

Thank you.

Correct, after another look a few minutes ago with the mounts loose it still sits a little off center looks like the tail of the transmission is pointed towards the passenger side, but when the motor mounts are snuged up it really points to the passenger side.

Progress is Progress.

Yes im using the holley crossmember but I couldn't use the adapters because I boxed my frame where they would normally go. And welded a tab for the crossmember to attach to.