Maiting season. Back from the dead
- Thread starter Happy camper
- Start date
Got the drivers side mockup done, new rims and tires should be here this week, once I get them on I'll finish with the welding on the front.
Found a piece of scrap pipe at work,
And figured why not do a shock tower brace instead of buying one.
That it for this weekend.
Found a piece of scrap pipe at work,
And figured why not do a shock tower brace instead of buying one.
That it for this weekend.
New front tires and rims arrived today.
I'm still abel to lay the crossmember on the ground.
Sure made those corvette rotors and calipers look small.
I'm still abel to lay the crossmember on the ground.
Sure made those corvette rotors and calipers look small.
Finished up the driver's side frame boxing today.
And made a rotisserie out of a couple engine stands. It should help out when I paint the frame.
That's it for this weekend.
Hopefully next weekend I'll be able to get the motor and trans in the frame so I can mock up the trans crossmember.
And made a rotisserie out of a couple engine stands. It should help out when I paint the frame.
That's it for this weekend.
Hopefully next weekend I'll be able to get the motor and trans in the frame so I can mock up the trans crossmember.
Came to the conclusion my control arms won't work in the front, I ordered some extended arms, that will allow me to run the shocks from the lower arm like this .
I was abel to get the driver's side transmission mounting mount welded in.
Hopefully next weekend I'll get the motor and trans mocked up so I can drill the holes for the crossmember.
Now I just have to wait for the control arms and shock mounts to arrive so I can finish the welding .
Then ill be abel to start prepping and painting the frame.
I was abel to get the driver's side transmission mounting mount welded in.
Hopefully next weekend I'll get the motor and trans mocked up so I can drill the holes for the crossmember.
Now I just have to wait for the control arms and shock mounts to arrive so I can finish the welding .
Then ill be abel to start prepping and painting the frame.
Motor ,transmission, and exhaust mocked up. Everything seems to fit .
Now to pull it out and notch the frame for the A/C compressor.
Now to pull it out and notch the frame for the A/C compressor.
Still waiting on my new control arms and shock mounts. I haven't done much to the frame because of that .
But did decide to upgrade those tiny c6 calipers and rotors. Ended up going with the blazer spindles, cadillac ats brembo calipers and c6 z06 rotors, hopefully they will look a little better in the wheels.
But did decide to upgrade those tiny c6 calipers and rotors. Ended up going with the blazer spindles, cadillac ats brembo calipers and c6 z06 rotors, hopefully they will look a little better in the wheels.
