Search results

Want to put in a floor shifter on my 85 with bench seats, what shifters will work with 4 speed trans and full length headers? Might also switch to buckets eventually, but for now I'm hoping to find something that will work with a bench

nice! looks awesome!

looks like it was only leaking from the cap, did you try just replacing the gasket first?

i know you said you added the zinc additive during break in but did you follow the correct procedure? may have a flat cam lobe. you can try relashing the valves

red wire to one side of the circuit breaker then another piece of red wire from the other side of the circuit breaker to the battery. Grey/back goes to the installed thermo switch, purple goes to the positive wire on the fan, then you also need to ground that black wire (ground) coming from the...

It depends on what you want to do, but for the average person yes you do. You need to connect the power wire from the relay to the battery, then your going to need a switched 12v source so the fans only turn on when the car is running. then the ground usually comes from the thermostatic switch...

yup second link should work, if you get a good deal on them

yea they should if they fit malibus and monte carlos, how well? idk :rofl:

now that im looking at it again, that cable is too loose, it needs to be tight even when idling

nice! 8) To make adjustments you don't have to move the bracket back. You just have to press in the little tab and push the slider in or out ONE click at a time then test drive until your happy with it. One little click makes a big change. I like that bracket, I'm going to look into getting one.

I have the same cam as you, and I find it likes a lot of timing at idle (initial), which can put your total above where you would like it to be and cause detonation. Say for ex. if you found your motor liked initial timing at 20 btdc and your dist. had 26 degrees of mechanical advance, that...

installed my TA girdle today I love it lol Still need to bleed my brakes after my s10 wheel cylinder and aluminum drum upgrade. Last thing I really want to upgrade is the alt to a CS130 or CS144 and I am on to body work and paint.. I am still undecided on what I want to do, part of me wants...

this is how my piece of junk looks like at the moment, gotta finish installing my TA girdle, then pretty much all that is left is paint

you NEED to buy this bro its only $20. I have the same carb and trans

make sure you get the holley carb geometry corrector for tv cable or you will ruin that trans fast. It wont work how it is suppose to without it. I know they keep telling you they will make it work but I don't trust nobody :rofl:

Thanks pictures do them no justice, I really like how they came out and that they can be touched up easily from time to time. Glad to be an innovator of something for once in my life 8) :rofl:

thanks! it looks much much better in person, but I have kat litter dust being kicked up all over the place from my shift kit install.

Just finished up my rear drum brake upgrade, since there aren't too many pics of the process i figured i'd share mine. first replaced stock 3/4" bore wheel cylinders with S-10 7/8" bore. I also highly recommend using wheel cylinder bracket because the retainer is a pain in the *ss to get in and...

I feel you bro,im here in LB, even with a garage my *ss don't want to be out there in the rain, damn wind is too cold :rofl:

finally out of school and making some progress finished running my new wires and finishing up my fusebox wiring, got it all back together and took it for a ride, trans feels alot better with the shift kit, not more slipping when accelerating and shifts are not to hard, everything stayed cool and...