quadrajet

  1. Supa.Slo.SS

    WOT Hesitation/Non-Shift - RESOLVED

    Over 2 years ago I made new thread about my issue with my Monte at WOT, well I finally got around to resolving the issue. In short, I had a feeling it was ignition/fuel related issue so I finally got around to "rebuilding" the carb & now my issue is resolved. I wish I could pin point where the...
  2. Phillip

    I've got fuel and spark... why won't she start?

    Hi All! I'm afraid I'm one of many to make my first post a cry for help. I'm at the end of my rope with our 84' Caprice Estate 305. The short story is, I rebuilt the Rochester Quadrajet meticulously, assuring everything was done right, and now she won't run. The car ran before the rebuild, but...
  3. oxide80

    CCC system and E4MC Questions....

    So I'm looking to pick a few brains here, I'm messing around with the semi-rat 87 442, the car is just a hobby car I've having fun with.. Little back ground when I purchased the car the CEL was on and found no fuse for the ECM in the fuse block. Put in a fuse, CEL went out. Any ways I'm...
  4. Christines86Cutty

    New to this..

    I have a 1986 Oldsmobile Cutlass Supreme Brougham, with the 307 5.0 V8 and 4bbl rochester quadrajet carb. I just replaced the cylinder heads and gaskets. It has some issues, but it's mine so I'm trying to figure it out a little at a time. Hopefully I can find some ideas here. I need the air...
  5. TX762

    Upgrading carb E2ME to E4ME ... What else do I need?

    Good day folks, I'm planning to upgrade my El Camino's computer controlled 2 barrel to a computer controlled Quadrajet. Here's what I know I need to replace to get it done: 1) Quadrajet - National Carburetors reman E4ME 2) 4-bbl intake manifold - Speedmaster Holeshot (EGR) 3) Fuel hard line to...
  6. lelanb

    QJet to Holley Help

    I just purchased a 85 supreme with a sbc 350 swapped into it. I'm extremely new to carburetors but i know the qjet on it is shot and i have access to a new free 4160 holley (1850s). besides an adapter plate, what else do I need to make this work, like what about the choke and everything

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor