80 442 full powertrain swap

[Kelvin's80442]

A very nice header, should be worth a few hp over the Flowtech or Hedman full length. Should be for the 2 million dollars Canadian, a set costs.

Yes alot told me to go with ARH. Finally found a good used set, not perfect but will work well. A big upgrade from the Thortons I was going to use.

Yes Trudeau has to fund his family some how

 

[olds307 and 403]

Yes alot told me to go with ARH. Finally found a good used set, not perfect but will work well. A big upgrade from the Thortons I was going to use.

Yes Trudeau has to fund his family some how

Yeah, I saw that set, a good deal, might be a double digit gain over shorty headers. I see our fearful idiot leader is running our debt to a projected 1.2 Trillion! The pandemic only accounts for $368 billion of that. Glad you can still afford to finish this, no shortage of work as a fuel truck driver for me or my Wife as a Nurse. I am pushing forward with my Olds 403 based 424, sending in the block at the end of summer. Eagerly awaiting updates.

 

[Kelvin's80442]

Yeah, I saw that set, a good deal, might be a double digit gain over shorty headers. I see our fearful idiot leader is running our debt to a projected 1.2 Trillion! The pandemic only accounts for $368 billion of that. Glad you can still afford to finish this, no shortage of work as a fuel truck driver for me or my Wife as a Nurse. I am pushing forward with my Olds 403 based 424, sending in the block at the end of summer. Eagerly awaiting updates.

Yep terrible where we are heading, not good. I am fortunate,heading back to Northern BC again to work on the Coastal Gas Link. I would hold off in finishing but the motor been sitting since xmas and transmission build is almost complete, so just push through so Kelvin can enjoy his graduation gift

 

[Kelvin's80442]

Any one know if this will fit with a double hump crossmember?
Any one deal with this company before?
Thanks

 

[pagrunt]

Which double hump X-member are you using? If using a G Force it'll be OK. My kit would clear my G Force but since they can't make a correct passenger side MCSS style tailpipe my kit is going to be used for extra pipe sections.

 

[Kelvin's80442]

Which double hump X-member are you using? If using a G Force it'll be OK. My kit would clear my G Force but since they can't make a correct passenger side MCSS style tailpipe my kit is going to be used for extra pipe sections.

Yes G Force I am using

 

[Kelvin's80442]

Another piece of the puzzle is in!!!!

 

[Kelvin's80442]

Hello again all.
Been busy at work, been away from home to do any work on the 442.
Any who, I have found a set of Blazer kuckles and hubs to upgrade the brakes. Now question is, need great quality rotors, calipers and pads. What and where would I look?
Thanks

 

[fleming442]

I thinks I gots deez:

More Information for POWER STOP KOE2004

www.rockauto.com

 

[rogue_ryder]

Great Build! I love the 1980s with that grill; I was looking high and low for one before I settled on my 85. Very good choice in parts too.