Aluminum door panels

[Chris Van]

They were being discussed on here a few days ago and I finally found the link I was looking for.....
Check these out....
http://www.yellowbullet.com/forum/showt ... p?t=329358

 

[3XBrownCutty]

i like the first pic. gets rid of the armrest and doorbar problem but keeps the stock upper panel nest idea. not sure if i like the stock handle there though :lol:

 

[dfields87]

like the panels, do you know what they wanted for a set?

78' cutlass supreme

 

[Chris Van]

I really can't remember the prices but if I'm not mistaking I think they were like $125.00 a set for plain aluminum and something like $10 dollars more for a color. I know I have seen prices posted somewhere before.
I am gonna be ordering a set of the lower ones for my car. After making the cage a 10 point I had to let the lowers go on mine. I like the look but I am sure hoping to come up with something better looking than the stock door handle too.

 

[papabearxl]

Very nice. I had been thinking of fabbing some, but this would be a lot easier............

 

[kuruption109]

😀
i like the full type.. cost?

 

[3XBrownCutty]

I like the look but I am sure hoping to come up with something better looking than the stock door handle too.

you could go with the TNT handle. it only works with a full alum. panel i believe.

http://www.tntraceshop.com/Instructions_200165.htm

 

[kuruption109]

I like the look but I am sure hoping to come up with something better looking than the stock door handle too.

you could go with the TNT handle. it only works with a full alum. panel i believe.

http://www.tntraceshop.com/Instructions_200165.htm

thats a bad *ss mode to the gbody hummmmm..

 

[1979ratrod]

i just put a set of the tnt ones on my el camino over the weekend, they look so nasty

 

[Chris Van]

I like the look but I am sure hoping to come up with something better looking than the stock door handle too.

you could go with the TNT handle. it only works with a full alum. panel i believe.

http://www.tntraceshop.com/Instructions_200165.htm

I have looked at those in the past too. I would really prefer to do just the bottom half and keep the top half stock. I like the aluminum door handle too but I would need to mount it in the lower half of the door.