I will blast it down with brake clean. I picked up a 5 and 6 foot copper nickel line.
Brake tubing on G bodies?
- Thread starter olds307 and 403
- Start date
- Status
Haven't needed to do any brake lines one something worth it, but those copper nickel lines look soooo good!
with that type of line you will not need the tube bender tool...and I would suggest to try a few flares before you do it on the line you are using. The material is softer them ametal line and I found it takes a little practice to get the flares right without digging too deep into the soft material.
The 5 foot flared on both ends with fittings was the perfect length. Man, is this stuff easy to work with, put on, no leaks. I ended up bleeding both sides, pedal was soft once I backed out and took it for a drive. This 350 runs really nice, can hardly wait till the new rad comes and I can hit the open road.
wait a sec, you can't do this job with no problems.....you need to redo the job and f*k something up that takes a few boxes of popcorn to fix....
- Status
Similar threads
