Well, I found some time to work on the Cutlass in the last couple weeks. Not much time, but did get the 700R4 installed and a cross member fabbed up. I also found the radiator that I had in the car with my SBC and was able to reuse it instead of ordering a new one for the car. I filled the engine and trans with oil and attempted to crank it over, but my SBC mini starter that I modified to run is not quite right. I had it spaced too far from the fly wheel, something I did not check properly during install. Unfortunately, the mounting block will need to me machined down to bring the clearance in. I worked on that some this morning, but still have too much clearance. I am not sure that I will be able to machine it down enough to work. I may have to bite the bullet and order one for an Olds.