Firing problem

[83gbody]

83 cutlass supreme 305 dizzy fires then stop what could be the problem

 

[tc1959]

83 cutlass supreme 305 dizzy fires then stop what could be the problem

This is a no Dizzy zone.... Read the Old man Thread. Bi+C#

 

[my86442]

83 cutlass supreme 305 dizzy fires then stop what could be the problem

This is a no Dizzy zone.... Read the Old man Thread.

agreed 8)

 

[83gbody]

What I can't use dizzy

 

[83gbody]

Let me correct myself my distributor fires then stops

 

[my86442]

have you checked your ignition module? After so much electricity, it gets hot. If it get hot enought to not be stable, itll quit. That or do you have electronic module grease underneath your ignition module? that grease acts as a heat insulator keep the module from burning up or shorting out

 

[83gbody]

No I haven't check it and there is no grease under the module.

 

[my86442]

take that module to any parts house and ask them to test it 3 or 4 times. thats about how long it takes to show good or bad. sometimes 5 or 6. what the machine will do is test the start side, idle, rpm rev and amount of voltage it should handle. If it fails one of those, it needs replaced. if it tests out fine than put some of that grease under it and go from there. its usually on the counters on racks. lmk what happens

 

[83gbody]

Ok will do

 

[83gbody]

Nobody knows how to test ignition module at part stores. So what should I do now?