Gas tank venting

[johnnunez29]

I use Rivnuts for most any place on my cars I would typically install a sheet metal screw. Also works well on fiberglass and plastic.

Threaded Insert Riveter Kit

Amazing deals on this Threaded Insert Riveter Kit at Harbor Freight. Quality tools & low prices.

www.harborfreight.com

💪🏼 thank you sir

 

[mikester]

💪🏼 thank you sir

Just stick the thing in the back next to the fill. Access to the screws in the trunk. Easy. If there is a smell it will be behind you. 😉

 

[johnnunez29]

Just stick the thing in the back next to the fill. Access to the screws in the trunk. Easy. If there is a smell it will be behind you. 😉

What thing? The vac manifold? I need to figure out where to mount the trans dip stick too. We getting to that point on this build.

 

[mikester]

What thing? The vac manifold? I need to figure out where to mount the trans dip stick too. We getting to that point on this build.

My mistake. That comment was for the OP. LOL

 

[1987Olds442]

When adding that valve did you guys remove the restriction on the inside plate for the vent line on the sender unit? I added this valve and I still have filling issues. I cannot freely blow or have suction on the sender. Debated removing tank to braze on new fitting to the neck. Or to remove that small metal plate.