Hi everyone 1987 cutlass

[melloelky]

Welcome to the site Paul,congrats on picking up a nice car outside of taxachussets, new england's rough on cars.

 

[Longroof79]

Welcome to the site, Paul.
Looks like you found a nice clean example. Sometimes it's worth traveling out of state to find the right car. Good luck with it! It should be a nice cruiser with the 403.

 

[Opie Knievel]

Welcome to the forum. Looks like you found a really clean Cutlass. If you need help with anything, just ask. There's a lot of skill and knowledge on here.

What are your long term plans for the car?

 

[oldsofb]

Welcome from MD. I too have a soft spot for the 87 😎

Glad to hear it's staying Olds. A 403 should make that a fun ride. Look forward to seeing the progress.

Hutch

 

[Paul Saulnier]

The goal is to have the car on the road by May to hopefully drive it to the Oldsmobile show here in Mass on May 20th. I still have alot to do. I have to figure out a kick down switch for the th400 transmission, a crossmember and a exhaust. I searched all around for a clean cutlass it could use a paint job at some point. The plan for this car is basically to be loud, fun to drive and horrible on gas.

 

[vanrah]

Welcome Paul; I love the steering wheel & horn button. And I would suggest you buy a after market X member as in the future you will be adding HP, cam, headers & what not. The extra beef of an after market unit will help reduce flex. You only buy one X member once. Take care & good luck, Ole' Bob.

 

[Paul Saulnier]

I saw the button online for $16 So I had to order it. I already a bunch of stuff for the car new radiator and hoses a set of springs for the front end. I hope to be able to use the headers the 403 had on it when it was in the trans am. If not I'll be shopping for a set

 

[Clutch]

I saw the button online for $16 So I had to order it. I already a bunch of stuff for the car new radiator and hoses a set of springs for the front end. I hope to be able to use the headers the 403 had on it when it was in the trans am. If not I'll be shopping for a set

F-BODY headers don't fit G-bodys

 

[Paul Saulnier]

F-BODY headers don't fit G-bodys

Of course they don't that would be too convenient. Any recommendations?

 

[Paul Saulnier]

Welcome from Delaware! Nice looking Cutlass.

That's where the cars from