Jegs stainless exhaust kit, super deal

[pagrunt]

Price for the kit quoted in the OP's post is now at 399. Appears the deal is over.

Just keep stalking thier site & the lower price will show up again

 

[MrSony]

Looking at these kits again... anyone use a gforce x member and have fitment issues using this kit?

 

[pagrunt]

Not if you're using the included mufflers. I trimmed down the pipes at the muffler joints since I'm using the Pypes mufflers.

 

[Wraith]

Jegs fitment on rear of a Malibu wagon. It is VERY close to the gas tank shroud, we are looking at getting just a bit more clearance.

 

[fleming442]

Jegs fitment on rear of a Malibu wagon. It is VERY close to the gas tank shroud, we are looking at getting just a bit more clearance.

Chop saw to the tail behind the wheel and DONE!

 

[MrSony]

Jegs fitment on rear of a Malibu wagon. It is VERY close to the gas tank shroud, we are looking at getting just a bit more clearance.

What cross member do you have?

 

[Bitterman]

Im running a force x member. I have not done a complete install, just a mockup on the drivers side. I do not see any issues so far with the g force x member. If I get a chance in the next few days, I'll try and snap a pic with both pipes after the headers.

I may have missed it... are you running headers? I have flotech tri Y on my sbc 383.

 

[MrSony]

Im running a force x member. I have not done a complete install, just a mockup on the drivers side. I do not see any issues so far with the g force x member. If I get a chance in the next few days, I'll try and snap a pic with both pipes after the headers.

I may have missed it... are you running headers? I have flotech tri Y on my sbc 383.

no headers yet. just a SBB with manifolds.

 

[Wraith]

What cross member do you have?

We used a G-force crossmember.