Losing my mind!!! Where do these go?!?!?!
- Thread starter Blake442
- Start date
- Status
Come on man, don't keep us in suspense any longer..you're killin' us
he's going to loose more than his mind if he keeps this up.....😎
Nobody got it!
I should've clarified that I left 100% of the wiring in place while I had my car apart.
The rockers were already occupied with the correct wiring channel.
As I mentioned, these did not have any wires running thru them...
Turns out they slip over the outer edge of the channel that runs along each side of the rear cargo floor.
The D-shaped portion fills the gap so that the large interior panel will sit snugly in place along the bottom...
Problem solved!
I should've clarified that I left 100% of the wiring in place while I had my car apart.
The rockers were already occupied with the correct wiring channel.
As I mentioned, these did not have any wires running thru them...
Turns out they slip over the outer edge of the channel that runs along each side of the rear cargo floor.
The D-shaped portion fills the gap so that the large interior panel will sit snugly in place along the bottom...
Problem solved!
Holy smokes....you're right...and I've handled those pieces too... just forgot all about them. I had put them back, though. Man, do I feel like a schmuck...😳
I used my super-sleuthing skills!
This picture shows the outside edge of the channel that the piece sits on.
There are gaps about 1" long to make access for the screws that come in from the side.
The wear marks on the backside of the interior panel did not match the channel with the gaps.
Hold the piece up to the inside of the panel and the wear mark is the same length... Eureka!
This picture shows the outside edge of the channel that the piece sits on.
There are gaps about 1" long to make access for the screws that come in from the side.
The wear marks on the backside of the interior panel did not match the channel with the gaps.
Hold the piece up to the inside of the panel and the wear mark is the same length... Eureka!
Great detective work. Now, see those "S" shaped pieces that cover the transition from narrow to wide floor behind the wheel wells? I took mine off and now I can't get them to fit back on for sh*t.
- Status
Similar threads
