My 1986 Ttype Turbo LY6 6.0 4L80e
- Thread starter Shap86lsxT
- Start date
- Status
VERY nice 86 Ttype. The license plate should say R O C K E T. I see you have the VHX gauges in it. Where exactly did you end up putting the control box for the gauges. I have the same gauges but not installed yet and I was wondering if they could fit directly behind the gauge panel itself. Also do you need to install the sending units for water, oil pressure or are you reading them directly from the PCM through the diagnostic port? Thanks Rich
Thanks man! I mounted it behind the whole dash for more room to run everything. It comes with new sensors that i used on the ls motor, but you can program the unit to work with different/stock senders also.
Thanks for the info. Much appreciated. I also noticed that you have the GTO seats in it. I also have them to put in my car. How hard of a job? Any tips you can share. I see that they also fit with the original console. The fit must be tight. They look awesome in there. The car that I am working on is an 87 Ttype with a modified LS376/480, Finishline Transmission . Mosher M9 rear, & Mark Williams 7075 Aluminum driveshaft. The car should have been done back in July but I am having a big dispute with BRP & Hedman Headers over the fitment. Headman has my right side header since July and refuse to do anything, even sending me my header back. I will wait a while because I am pursuing this in another direction . After my dispute is settled I will post the problems in the Vendor section comments. So if you can give me any tips on the seat brackets it would surely be appreciated. I love your build. Rich
- Status
Similar threads
