Hey guys i'm new on here, just lookin for some advice. First i'll give you a little backstory. The car is a 79 El camino with a 350/th350/7.5" combo, the drivetrain has no more that 10,000k on it. Ive owned the car for about 10 yrs and it was my daily driver back when I was living paycheck to paycheck so it goes without saying when an issue came up I didnt have much money to throw at it. Now the car has sat for about 7 years and I have the cash so I figured I would get her going again. The motor is a 350 with a few add ons; Roller lifters, aluminum intake, holley street avenger, cam, exhaust. Back in the day the nail in the coffin for the car was my radiator went and I severely over heated the engine and it never ran right after that. It would blow out the pan gasket and burn oil like crazy, this to me screams RINGS! SO yesterday I pulled the motor and popped the heads off and every piston has a pretty good amount of oil on it. The plan is too pull it all apart and re-ring, new bearings, gaskets, etc. I guess my question is does this sound like i'm on the right path or is there another underlying issue I should be looking at. Also is there any other part I should replace because of the over heating? I dont want to go through all this trouble and then have the same issue again. I would assume if it were anything valve seal related all 8 cylinders wouldnt look almost identical