removing diff center shaft (differential )

[cyrus_the_great]

i was trying to replace axles bearing& seals ...

removed diff cover and that small locker screw ...
but the shaft can not come out yet ... shaft can move a little back and forward ... i used some hammer to move the shaft and it 's there yet

 

[67rstbkt]

Re: removing pin gear (differential )

You need to use more hammer

 

[chevy2480]

Re: removing pin gear (differential )

The pin is broken of from the locker screw/bolt you removed i bet . It may have a thread or two still attached. I used a small screwdriver and spun mine out until i was able to get a magnent to pull it all the way out. Most likely thats still holding pin from being removed

 

[cyrus_the_great]

Re: removing pin gear (differential )

The pin is broken of from the bolt you removed i bet . It may have a thread or two still attached. I used a small screwdriver and spun mine out until i was able to get a magnent to pull it all the way out. Most likely thats still holding pin from being removed

if u mean that small blot what lock the shaft in place .. i should say that i got it in hand without problem and it 's ok and not broken

 

[cyrus_the_great]

Re: removing pin gear (differential )

You need to use more hammer

that 's one of my options

 

[chevy2480]

Re: removing pin gear (differential )

The pin is broken of from the bolt you removed i bet . It may have a thread or two still attached. I used a small screwdriver and spun mine out until i was able to get a magnent to pull it all the way out. Most likely thats still holding pin from being removed

if u mean that small blot what lock the pin in place .. i should say that i got it in hand without problem and it 's ok and not broken

Ok was just a suggestion because the unthreaded tip that goes threw pin tend to brake im sure you already know that.

 

[cyrus_the_great]

Re: removing pin gear (differential )

The pin is broken of from the bolt you removed i bet . It may have a thread or two still attached. I used a small screwdriver and spun mine out until i was able to get a magnent to pull it all the way out. Most likely thats still holding pin from being removed

if u mean that small blot what lock the pin in place .. i should say that i got it in hand without problem and it 's ok and not broken

Ok was just a suggestion because the unthreaded tip that goes threw pin tend to brake im sure you already know that.

thank you

 

[cyrus_the_great]

Re: removing pin gear (differential )

no way ... i don't know what to do ...

 

[tc1959]

Re: removing pin gear (differential )

I have always used a pick to unscrew the broken pin they always have one or two threads left on them. You can pick up a set a Sears or harbor freight for a few bucks.

 

[cyrus_the_great]

Re: removing pin gear (differential )

the shaft has a hole that locker bolt goes in and i removed the locker bolt without problem and not broken ... i can post some photo from that locker bolt if u guys don't accept my word 😀

but the shaft moves 0.5" up to down only and stuck there ...