I welded in a small patch on the bottom of the quarter and am planning on building a patch for th area right in front of the wheel opening but I believe I may have gotten a little impatient. I did not leave an expansion gap at the top of the patch when i began welding which may have caused my issue or the fact that i burned through the areas on either end of the patch and then filled them too quickly. The metal around the patch was very thin and I probably should have made the patch larger and cut more material away to begin with but here's my dilemma... the area that the screw driver is pointing to is pulled in or has a shallow dent that I think was caused by me welding the patch in as I never noticed it there before (not that I was looking??). My question is, would it be advisable to make a cut with a 1/8" cut off wheel above the patch and then stitch it back together with the mig to hopefully shrink the area and pull the dent out or am I dreaming?
Thanks in advance
Thanks in advance