Torque specs?

[poncepr64]

I have an 85 Buick Regal Limited I am working on. Still stock. 3.8l/3 spd trans/ digital dash.
It has been sitting the past 15 yrs. Going through it and replacing as I go.
I can seem to find much info on torque specs when it comes to the spindle nut after replacing the rotors.
I can see some wear on the spindle, not bad considering the car is almost all stock. Nothing a little polishing can't fix.
So...any info on the torque specs would be greatly appreciated as this is holding me up form finishing the brake rebild.
Thank you
poncper64

 

[ELCAM]

Tighten the nut finger tight to eliminate all play then back it off to the first place you can install the cotter pin. The bearings are supposed to have minimum .003" play in them.

 

[poncepr64]

Tighten the nut finger tight to eliminate all play then back it off to the first place you can install the cotter pin. The bearings are supposed to have minimum .003" play in them.

Thanks for the info.