What did you do to your G-Body today? [2011-2018]

Status
Not open for further replies.

1LOW95GMC

Apprentice
May 9, 2012
96
0
6
OCS said:
recovered and installed the headliner
replaced the ugly(imo) :puke: pillowtop seats with some that I found in a 78-9 regal at a nearby picknpull
2012-09-l2_13-07-25_968.jpg

before:
2012-08-205-17-00_461.jpg

after:
2012-09-02_13-06-_149.jpg
How do you get the headliner out after removing the trim?
 

SilverShadow87

Master Mechanic
Dec 3, 2011
422
3
18
OCS said:
recovered and installed the headliner
replaced the ugly(imo) :puke: pillowtop seats with some that I found in a 78-9 regal at a nearby picknpull
2012-09-02_13-07-25_968.jpg

before:
2012-08-20_15-17-00_461.jpg

after:
2012-09-02_13-06-52_149.jpg
that headliner looks rather crispy...did the material have a foam backing?
 

OCS

Apprentice
Jul 15, 2012
99
2
16
MN
Had to remove those black clips that you can see in the pic, visors and the dome light. Taking it out sucked with the seats in, it was much easier putting it back in without the front seats being in the way.
I went the cheap route :oops: and did not use any foam backing. Either way it looks alot better than it did before.
 

chevy76monteman

Greasemonkey
Oct 9, 2006
150
1
18
Portland, Oregon, USA
Today I put a new set of center caps and valve stem caps (with Pontiac logo on them) on the Grand Prix's 14-inch turbines.

The other day I cleaned the turbines and put on some tire shine. They look 20x better than they did. They were covered in brake dust back and front.

IMG_1607.jpg


IMG_1608.jpg
 

shanghaismith

Greasemonkey
Mar 5, 2010
230
33
28
Macon, GA
Switched for 3/8" fuel line to 1/2" from the fuel cell/pump that supplies the nitrous plate. I am hoping to get more consistent runs. On the top end the motor some times stumbles and sets me back about 3 tenths.
 

442_olds

Apprentice
Dec 10, 2010
95
8
8
Got the new brake line for the rear brakes (from the junction block to the rear hose) hooked up. Still got to get clamps tightened down...including the one in the front. Not much room to work there between body and frame. Was extremely humid today...made it dirty and miserable to work, but at least it is hooked up now.
 

lildhix

Master Mechanic
Jan 9, 2011
478
1
0
put gas in her lol
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor